Universal data logger with 4 hardware inputs, internal barometric pressure sensor and Ethernet interface.
Multilogger can be permanently installed on an Ethernet network ou operate as a portable device.
Included is a traceable calibration certificate Complies with EN ISO / IEC17025.
The Multilogger is a battery-powered data logger able to measure and record sensor and electrical values through its inputs.
The data logger can be connected to Ethernet.
The measured values can then be viewed on a web browser, stored and downloaded for later analysis.
INCLUDED IN DELIVERY
- Traceable calibration certificate
- 3 AA rechargeable batteries
- Power source
- USB cable
- Wall bracket
- FREE Analysis Software
- Relative humidity
- Calculated values (dew point, etc.)
- Atmospheric pressure
- Two state signal
Temperature range : -10 to +60 ° C
Humidity operating range: 5% to 85% RH, non-condensing
Temperature compensation of humidity sensor: the whole temperature range
Measuring interval: 1s to 24h
Available temperature units: degrees Celsius, degrees Fahrenheit
Calculated values: dew point, absolute humidity, specific humidity, mixing ratio, specific enthalpy
Memory capacity (approx.): 1 values (non-cyclic recording), 000 values (cyclic recording)
Communication interface: Ethernet, USB, RS232
Ethernet communication protocols: WWW, SNMPv1, XML, DATALINK
Alarm protocols: E-Mail
Configuration: WWW configuration
Power : 230Vac / 5Vdc mains adapter (required for the Ethernet interface)
: Rechargeable NiMH batteries 3x 1.2V AA (emergency or portable application) or alkaline batteries 3x 1.5V AA (for portable applications)
Power cable : coaxial, diameter 5,5 x 2,1 mm
Dimensions: 178 x 95 x 37 mm (W x H x D), without cables attached