Multilogger hygrometer - universal 4-channel thermometer with 2 MiniDIN and 2 terminals

TECHNICAL DATA

Universal data logger with 4 hardware inputs.

Multilogger can be permanently installed on an Ethernet network ou operate as a portable device.

Included is a traceable calibration certificate conforms to the portable device EN ISO / IEC17025.s.

The Multilogger is a battery-powered data logger able to measure and record sensor and electrical values ​​through its inputs.

The data logger can be connected to Ethernet.

The measured values ​​can then be viewed on a web browser, stored and downloaded for later analysis.

INCLUDED IN DELIVERY

• M1320
• Manual
• Traceable calibration certificate
• 3 AA rechargeable batteries
• Power source
• USB cable
• Support mural
• FREE Analysis Software

External probes are not included.

MEASURED VALUES

- Temperature
- Relative humidity
- Calculated values ​​(dew point, etc.)
- current
- voltage
- Two state signal
- Impulses

Temperature range : -10 to +60 ° C

Humidity operating range: 5% to 85% RH, non-condensing

Temperature compensation of humidity sensor: the whole temperature range

Measuring interval: 1s to 24 h

Available temperature units: degrees Celsius, degrees Fahrenheit

Calculated values: dew point, absolute humidity, specific humidity, mixing ratio, specific enthalpy

Memory capacity (approx.): 1 values ​​(non-cyclic recording), 000 values ​​(cyclic recording)

Protection: IP20

Communication interface: Ethernet, USB, RS232

Ethernet communication protocols: WWW, SNMPv1, XML, DATALINK

Alarm protocols: E-mail

Configuration: WWW configuration

Power : 230Vac / 5Vdc mains adapter (required for the Ethernet interface)
: Rechargeable NiMH batteries 3x 1.2V AA (emergency or portable application) or alkaline batteries 3x 1.5V AA (for portable applications)

Power cable : coaxial, diameter 5,5 x 2,1 mm

Dimensions: 178 x 95 x 37 mm (W x H x D), without cables attached