Multilogger - four input thermo-hygro-CO2 meter, up to 50 ppm CO000

TECHNICAL DATA

Data logger universal with 4 hardware inputs and external CO2 probe.

Multilogger can be permanently installed on a network Ethernet or operate as a portable device.

Included is a traceable calibration certificate Complies with EN ISO / IEC17025.

The Multilogger is a battery-powered data logger able to measure and record values sensors and electrical through its inputs.

The data logger can be connected to Ethernet.

The measured values ​​can then be visualized on a web browser, stored and downloaded for later analysis.

INCLUDED IN DELIVERY

• AR005056
• Manual
• Traceable calibration certificate
• 3 AA rechargeable batteries
• Power source
• USB cable
• Support mural
• FREE Analysis Software

External probes are not included.

MEASURED VALUES

- Temperature
- Relative humidity
- Calculated values ​​(dew point, etc.)
- CO2

Temperature range : -10 to + 60 ° C

Humidity operating range: 5% to 85% RH, non-condensing

Precision temperature and dew point range: ± 1,5 ° C at ambient temperature below 25 ° C and RH> 30%
between -60 and + 80 ° C

Temperature compensation of humidity sensor: the whole temperature range

Measuring interval: 1s to 24 hours

Available temperature units: degrees Celsius, degrees Fahrenheit

Calculated values: dew point, absolute humidity, specific humidity, mixing ratio, specific enthalpy

Memory capacity (approx.): 1 values ​​(non-cyclic recording), 000 values ​​(cyclic recording)

Protection: IP20

Communication interface: Ethernet, USB, RS232

Ethernet communication protocols: WWW, SNMPv1, XML, DATALINK

Alarm protocols: Email

Configuration: WWW configuration

Power : 230Vac / 5Vdc mains adapter (required for the Ethernet interface)

: Rechargeable NiMH batteries 3x 1.2V AA (emergency or portable application) or alkaline batteries 3x 1.5V AA (for portable applications)

Power cable : coaxial, diameter 5,5 x 2,1 mm

dimensions: 178 x 95 x 37 mm (W x H x D), without cables attached