The analog input is configurable for different temperature sensors; Relay and SSR output, usable as command and alarm. Powerful power supply with extended range from 24 to 230 V AC / DC with galvanic isolation from the mains.
The soft start function with adjustable gradient gradient (degrees / hour) is provided.
Ease of use, media support and traceability
Throughout the Pixsys product line, we provide support for installation, programming and operation via our forum and via Skype.
The ATR236 temperature control interface offers user-friendliness, which is also supported by programming aids such as the MEMORY-CARD or LABSOFTVIEW parameterization software.
They are available in the video channel YouTube for programming. As with the entire range of PIXSYS products, thanks to the QR code, product traceability is guaranteed throughout its life cycle; Access to online information and documentation is also available on mobile by reading the QR CODE which refers to product specifications and warranty conditions.
48x48 (front panel) x 107 mm
24 ... 230V AC / DC ± 15% 50/60 Hz (galvanically isolated)
List it Now
4 digits 0,4 "green + 4 digits 0,3" red
Temperature 0-45 ° C, humidity 35..95 uR% (non-condensing)
Box: Noryl UL94V1 self-extinguishing, front panel: PC ABS UL94V0 self-extinguishing
About. 165 g
Front panel: IP54 (IP65 with gasket), box and terminals: IP20
Quick setup options
Memory card with / without battery, LABSOFTVIEW software, EASY-UP codes
Res. 16 bits, selectable for TC type K, S, R, J, (automatic compensation of the cold junction 0..50 ° C, ± 0,2% FS ± 1 Digit FS), thermoresistor PT100, PT500, PT1000, Ni100, PTC1K. NTC10K, (β 3435K)
4,1 ms (Frequency from 4,12 Hz to 242 Hz)
Relay 5 A - 250 VAC resistive load
PNP 12 VDC - 30 mA maximum
ON - OFF with hysteresis, P., PI, PID, PD proportionally
Manual or automatic
Locking of setpoint / alarm setpoint, Access to parameters by password
Absolute / Threshold, band, high / low deviation. Alarm with optional manual reset
Auto / Male function
Command output rate
Ascending gradient expressed in degrees / hour
2 set points
RS485 - MODBUS
(8 other products in the same category)