Programmer 48x96mm (1/8 Din), single loop control. Allows programming of 15 cycles / programs that can provide up to 45 steps / segments, freely configurable by the user. Simple and intuitive work cycle programming mode also for the unqualified operator.
This controller which is specifically designed for the automation of industrial ovens, environmental chambers, dryers and in general the management of thermal processes which require the programming of cycles / curves by controlling the process variable over time.
Universal inputs and outputs selectable as control, alarm / auxiliary, analog retransmission and / or RS485 serial. All options are configurable by keyboard without selection of external jumper. Powerful 24 to 230 volt AC / DC power supply with galvanic isolation of the power supply and between inputs and outputs.
Quick configuration wizard for the installer with MEMORY-CARD or LABSOFTVIEW Trend and Trend Registration software.
Box: 48x96 (front panel) x 123 mm
Power source: 24 ... 230Vac / dc ± 15% 50/60 Hz (selection 24 - 110 ... 230Vac with jumper)
Consumption: 5,5 VA, 4W
Pin up: 4 digits 0,4 "green + 4 digits 0,3" red
Operating conditions: Temperature 0-45 ° C, humidity 35..95 RU% (non-condensing)
Material: Box: Noryl UL94V1 self-extinguishing; Front panel: Silicone rubber V0
Weight: About. 350 g
Sealing: IP65 (front panel), IP20 (boxes and terminals)
Quick setup options: Memory card with / without battery, LABSOFTVIEW software