Web sensor - Hygrometer - Thermometer for compressed air with Ethernet interface ^*Step required

TECHNICAL DATA

Transmitter temperature and humidity.

T + RH probe in hard anodized duralumin for compressed air up to 25 bars with 1 m of cable.

Cable lengths of 2m or 4m are optionally available.

Humidity, temperature probe on a cable.

The measured values ​​are also converted to another interpretation of humidity: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.

INCLUDED IN DELIVERY

• T3511P
• Manual
• Traceable calibration certificate
• Free Tsensor configuration software
• Cloud for 3 months
  
  
  

MEASURED VALUES

- Temperature
- Relative humidity
- Calculated values ​​(dew point, etc.)

Relative humidity range: 0 to 100%

Accuracy of the relative humidity measurement: ± 2,5% relative humidity from 5 to 95% at 23 ° C

Accuracy of temperature output: ± 0.4 ° C

Resolution: 0.1 ° C, 0.1% RH

Measuring interval: 2s

Available temperature units: degrees Celsius, degrees Fahrenheit

Calculated values: dew point, absolute humidity, specific humidity, mixing ratio, specific enthalpy

Dew point temperature range: -60 to +80 ° C

Dew point temperature output accuracy (more details in user manual): ± 1,5 ° C for a dew point temperature greater than or equal to 10 ° C at an ambient temperature of + 25 ° C

Dew point temperature output accuracy: ± 2,0 ° C for dew point 0 ° C at room temperature + 25 ° C

Dew point temperature output accuracy: ± 3,0 ° C for dew point -10 ° C at room temperature + 25 ° C

Dew point temperature output accuracy: ± 6,0 ° C for dew point -20 ° C at room temperature + 25 ° C

Humidity sensor temperature compensation range: the entire temperature range

Housing operating temperature range with electronics: -30 to +80 ° C

IP protection: Electronics IP30, sensors IP40

LAN connection: RJ-45, 10Base-T or 100Base-TX connector

Communication protocols: WWW, Modbus TCP, SNMPv1, SOAP, XML

Alarm protocols: E-mail, SNMP Trap, Syslog

Configuration: T-Sensor, WWW configuration

Filtering capacity of the sensor cover: 0.025mm - filter with stainless steel mesh

Probe material: duralumin with black eloxal surface finish

Supply : 9 to 30Vdc, maximum consumption 1W

Power cable : coaxial, diameter 5,5 x 2,1 mm

Mechanical connection of the probe: G1 / 2 with O-ring

Probe cable length: 1m, 2m or 4m optional

Display unit dimensions: 88,5 x 93 x 39,5 mm (W x H x D), probe length 150 mm, probe diameter 18 mm

Weight : about 260g - 1m probe

Warranty: 3 years