The manufacturer provideshas a EU declaration of conformity.
Calibration - The final metrological control - comparison with standards or working instruments - is carried out for all products. The continuity of working standards and measuring instruments is ensured within the meaning of Article 5 of Law No. 505/1990 on metrology. We offer the possibility to supply the calibrated sensors (according to the requirements of EN ISO / IEC 17025) or in an accredited laboratory.
When mounting with a screw M4, it is recommended to apply a silicone or thermally conductive grease to the measured surface, which guarantees a faster response and minimizes errors in the measurement method.
-50 to 200 ° C (may be limited by the sensitive element, determine in the documentation)
Sensitive element type
Pt, Ni, NTC
IP 65 according to EN 60 529
DIN 1.4301 stainless steel
Case length L
shielded silicone 2 x 0,22 mm 2 shielded silicone 4 x 0,15 mm 2
0,16 Ω for 1 m cable for 2-wire connection
τ 0,5 <10 s (on a flat surface of the Al prism without paste)